How to adjust the parameters of laser marking machine?

What does fixed DPI stand for? Simply speaking, it is the number of pixels. The higher the standard value set in the 3D Dynamic Laser Marking Machine, the higher the actual effect of the marking, and the relative time will be slow. Here, the common setting standard value is around 300-600. , of course, you need to set the height to be able to do it. The Laser Marking Machine manufacturer here hopes to help everyone.

Then we will start to set the main parameters of the 3D Line Laser Marking Machine related photos. In most cases, we need to set the flipping and business network methods for the photos (there will also be a situation where the flipping is not selected. Under normal circumstances, it must be set Flip), after setting, go to expand, enable luminous solution, saturation adjustment is to control the actual effect of the photo, the milky white area is not laser marked, and the gray and black area is laser marked. I'm looking at progressive scan below. Here I usually use the wire-bonding method and I set it to 0.5. It is generally not recommended to use dual scanners. It is too slow to scan the upper and lower scanners, and there is no need to adjust the output power of the point.

The right speed is set up to 2000, the output power is up to 40 (the output power size is determined according to the product material, and the output power is set to 40 for reference. If the mobile phone case takes pictures, the output power can be set higher), and the frequency is up to 30. , the frequency size setting problem, the higher the frequency, the more concentrated the points out of the laser.