Laser marking machine manufacturers teach you how to use laser marker

Many factories now use laser marking machines, because they will mark their own or customer logo information on the products, but many factories are the first to come into contact with laser marking machines and have no understanding of its operation, so many laser marking machines. The marking machine manufacturer will teach customers to use it, but there are also unprofessional and unprofessional trainings that are not provided, resulting in people being unskilled in using it. The following Laser Marking Machine manufacturers will teach you how to use it.

How to use the laser marking machine?

1. The startup process is as follows:

1. Check the power plug of the laser cutting plotter to make it connect properly and reliably;

2. Insert the key power switch, turn 90o clockwise to the "on" position, and connect to the main switch power supply. indicator light is on;

3. Make sure the laser cutting head fungus button (emergency stop button) is in the pressed state;

4. Turn on the computer display screen and the main power switch of the desktop computer host;

5. Turn the red mushroom button in the direction of the arrow symbol to make it bounce up, then you can switch on the power supply of the laser cutting head, and the laser cutting head will run after about 1 minute;

6. Remove the lens cover; at this point, the laser marking machine is opened and completed, and the actual operation of laser marking can be carried out according to the instructions of the operator.

Second, the actual operation of Laser Marker

1. Double-tap the program icon to enter the program flow;

2. Select the laser marking document, double-click the date and time in the content of the mouse to make changes, click to confirm, and the changes are made

3. Laser marking detection and printing parts

1. On the operating table or production line, place an experimental piece with the same aspect ratio as the laser-marked product workpiece (select the laser-marked product workpiece as the experimental piece), and confirm that the experimental piece is indeed placed correctly;

Third, carry out laser marking according to the actual operation of laser marking monitoring software. In order to make the actual effect of laser marking good, the following process adjustments can be carried out:

1) Adjust the focal length of the lens according to the adjustment of the bald lift device;

Adjust the main parameters such as output power and laser marking rate in the laser marking mobile phone software;

Enter the mobile phone software, double-click the mouse to print out the date, drag the computer mouse left and right, and adjust the printed part to the appropriate part.

2) After the above process, the printing test can be carried out.

3) After the detection is accurate, laser marking on the product workpiece can be done again.

Fourth, the standby process is as follows:

1. Press and hold the red mushroom button (emergency stop button) to disconnect the power supply of the laser cutting head;

2. After confirming that the industrial computer is not running all mobile phone software, everything is normally withdrawn and standby;

3. Turn the key power switch 90o in the opposite direction to the "off" position, turn off the main switch power of the laser cutting plotter, and the indicator light is off;

4. Pull out the key and have a full-time person store it for the next application;

5. Tighten the lens cap.

After reading the above introduction, you should know how to use the laser marking machine. As people pay more attention to the product trademark, the factory will mark the customer's trademark when producing the product, so the laser marking machine will be used, which can It prints on various packages, and engraves exquisite patterns, trademarks and words, so people's demand for it is increasing, but it is recommended to choose a good laser marking machine manufacturer when purchasing, such as Feiquan Laser Technology Wuxi Ltd.