Laser cutting machine manufacturers' solutions for dust

Laser Cutting Machine is one of the common cutting methods, with high work efficiency and convenient use, and is widely used in processing plants. As everyone knows, there is no doubt that dust is generated when using laser cutting machines to cut various raw materials. After such tiny dust particles are generated, they will float in the air in large quantities, seriously affecting the air index and destroying the working environment. The high concentration of dust also causes harm to the employees who work in it, and often causes serious diseases such as respiratory diseases. Let's talk about how laser cutting machine manufacturers deal with dust problems.

At this stage, the common dust removal methods of laser cutting machines are divided into two types: dry type and wet type. The dry type is to upgrade the dust collection and cleaning dust collector equipment of a set of laser cutting machines, and the wet type is to place the cutting process on the water surface to generate a waterbed cutting service platform, which uses the driving force of the water flow to absorb dust and carry out cleaning. Through a comprehensive comparison of the two methods, the dry treatment method, especially the blow-suction cutting fume purification system, is very popular among users in processing plants, because it is easy to install and use. The smoke and dust generated by laser cutting are concentrated directly below the incision of the product workpiece, so this product has a suction port directly under the operating table, and the lower side of the operating table is cut into small evenly-proportioned suction areas. Collect in small cutting areas.

A sliding suction hose is also set up on one side of the cutting fume purification system service platform. When dust is generated, the wind speed of the air blower blows the dust to the suction port, thereby achieving the actual effect of small exhaust air volume and high dust collection rate.

The dust collected by the equipment will be sent to the dust removal host for filtering. The structure of the main engine is the same as that of the centralized dust removal equipment for electric welding and welding. The installed filter cartridge will block dust exceeding 0.3μm, and then carry out the cleaning process of cutting dust. This type of blowing and suction dust collector equipment has a processing efficiency of over 90% on laser cutting dust, and the actual effect is more prominent. Because of its simple installation and low cost, it has become a popular dust removal method for laser cutting machines.